Arb hydraulic Jack lowering

Gcfollett

Adventurist
Received my new arb Jack today and appreciate the quality build. I did have a problem getting the ram to retract after raising it a bit (12 inches or so). After much thought and looking at all the possibilities in my home garage...I ruled out trying to stand on the lifting lug while trying to engage bleed off lever. I finally decided on positioning lift lug very close to my steel bumper and using a long Jack handle (only) in a reverse fulcrum. Bitter end under bumper over lift lug and pushing down on other end while engaging bleed off lever. Took a few ‘stages’ to get there but worked very well and no hazards encountered. Hope this helps someone
 
Back
Top Bottom