Gallowbraid
Adventurist
More wiring progress today. Pulled a group of 5 wires through to the storage area behind the drivers side rear seat. Under hood I fed these up through a grommet in the plate I fabbed.
Behind the seat i drilled two holes to allow a pass through for the wiring and installed rubber grommets.
Everything was loomed and run through factory grommets to exit under the truck in the driver's foot well.
Made some quick initial connections to test things:
After this i brought constant 12v power into the storage box using one of those 5 wires i pulled. This went into a 6 circuit terminal to shoot into the relays on the relay board. Two other wires were used to provide power to the arduinos which are in turn powering the relay board and Nextion screens. I pulled a 6 wire cable back to the engine bay to carry the relay outputs into the engine bay. Everything was terminated and connected in the storage area so now I just need to make final connections under hood. So close to being done but I ran out of daylight.
Behind the seat i drilled two holes to allow a pass through for the wiring and installed rubber grommets.
Everything was loomed and run through factory grommets to exit under the truck in the driver's foot well.
Made some quick initial connections to test things:
After this i brought constant 12v power into the storage box using one of those 5 wires i pulled. This went into a 6 circuit terminal to shoot into the relays on the relay board. Two other wires were used to provide power to the arduinos which are in turn powering the relay board and Nextion screens. I pulled a 6 wire cable back to the engine bay to carry the relay outputs into the engine bay. Everything was terminated and connected in the storage area so now I just need to make final connections under hood. So close to being done but I ran out of daylight.